User Manual
RiX 70 DC
2
1 Introduction
Thank you for trusting our company and choosing RiX-70 DC as your Intraoral X-Ray System.
This manual, supplied with the system, is an integral part of the product; please keep it close to the
unit’s installation location; it describes the parts and components of your RiX-70 DC and explains the
correct operation of the unit by observing all the relevant safety measures when handling X-ray
equipment. The original language of the User Manual is Italian.
1.1 User Recommendations
Carefully read and follow the warnings and safety instructions
contained in the
User’s Manual.
Use the device in accordance with the procedures explained in the present
manual, and do not use it for purposes other than those it was designed for.
Failure of the user to properly maintain the equipment may relieve Trident or his
dealer, from responsibility for any injury, damage, or non-compliance, which
may result.
Report promptly to Trident or to its dealer any accident involving this device or
any alteration in features and/or performances which could cause death,
injuries or health hazard to Patient and/or Operator.
1.2 Safety Recommendations
Carefully read all the safety instructions to avoid potential hazards that could result in personal
injuries or could damage your equipment.
This table contains important information regarding the system, the operator
and the patient safety.
Please read this table very carefully.
RiX-70 DC is an electro-medical device that must be used under the supervision
of a doctor or a person with vast experience in radiology.
Do not modify the device mechanically and / or electrically during or after the
installation.
RiX-70 DC is built for continuous operation with intermittent load; therefore, it is
required to observe the cycles of use allowing the dissipation of heat
accumulated by the radiation source.
RiX-70 DC must be switched off when using electro surgery or similar devices.
Make sure the installation of your X-Ray unit is carried out only by qualified
personnel. Absolutely avoid provisional electrical connections and verify that
only the parts (screws, nuts, bolts, etc.) recommended by the manufacturer are
used.
The installation area must comply with the current regulations pertaining to
radiology in the country of operation.