Trident Raider, Инструкция по установке и эксплуатации, Страница: 46 / 94

46
Raider Installation and Operation Rev. 1.4.2
How To Enter The Value of a CTCSS Tone
The Raider supports all 38 CTCSS tones per repeater. These codes are reusable on a per repeater
basis. CTCSS tone entry is similar to the DCS code entry except that CTCSS tones are not entered
into the System Parameters. Instead, you must select CTCSS Operation in the User Parameters and
use the CTCSS translation table in Appendix A.
There are two key points necessary to understanding the configuration of CTCSS tones. Please
read these points very carefully.
1.
Each
CTCSS TONE
is permanently assigned to a
CTCSS VALUE
as found in the table
in Appendix A.
2.
A
CTCSS TONE
is assigned to a
User ID
in the
User Parameters
(under Edit
Parameters) by completing the following four steps. Press the Space Bar to change
settings.
a.
Set the parameter "CTCSS/DCS Overlay =" to
ENABLE
.
b.
At the parameter "CTCSS/DCS Number =" type in the
CTCSS VALUE
that
represents the desired
CTCSS Tone
.
c.
Set the parameter "CTCSS/DCS Mode =" to
CTCSS Operation
.
d.
Set the parameter "User is" to
VALID
.
Example:
We're going to assign CTCSS Tone number 27 (167.9) to ID code 01101.
1.
In this manual, locate Appendix A. The CTCSS
TONE
s, 1 through 38, are each given a
VALUE
, 001 through 038. Locate CTCSS
TONE
167.9. Make note of its corresponding
VALUE
which is 027.
TONE FREQUENCY VALUE
1 67.0 Hz 001
2 71.9 Hz 002
etc. etc. etc.
2.a.
From the Main Menu select
"E"
for Edit Parameters then select
"U"
for User Parameters.
2.b.
When Prompted for a "User ID:" enter 01101. Press ENTER.
2.c.
At the "CTCSS/DCS Overlay =" prompt, press the Space Bar to set to
Enable
. Press ENTER.
2.d.
At the "CTCSS/DCS Number =" prompt, type the
VALUE
of tone 167.9 (027). Press ENTER.
2.e.
Set CTCSS/DCS Mode =
CTCSS Operation
.
2.f.
Press the Space Bar 3 times to move to "User is". Press the Space Bar again to set to
VALID
.
User Status:
ID = 01101
CTCSS/DCS Overlay = Enable, CTCSS/DCS Number =
027
CTCSS/DCS Mode =
CTCSS Operation
Audio Companding = No
Full Duplex = No
User is
VALID