26
The remote control transmits infrared signals to the receiver. Please get the functions
of the buttons from the overview of the remote control.
Point the remote control at the front of the receiver and press the
appropriate button once for a short time.
For the remote control you need two batteries of the micro type:
LR 03/AAA/1.5 V Supplied
Open the battery compartment.
Observing the polarity, put two batteries into the battery compartment and close the bat-
tery compartment cover again carefully until the cover locks in position.
Change batteries that are becoming weak in good time.
Always change both batteries at the same time and use batteries of the same type.
If a battery has leaked, put protective gloves on and clean the battery compartment with
a dry cloth.
Caution!
Batteries may contain toxins that can damage your health and the environment.
Therefore dispose of the batteries in absolute
accordance with the legal provi-
sions in force. Never throw the
batteries away in the normal household refuse.
Remote Control
25
To peak the dish and get maximum signal level you need to adjust the elevation.
To do this, gently pull on the top of the dish. You will need somebody to watch the
screen and advise you of the best received signal level.
When you have peaked the dish for maximum signal level, and checked that you are
receiving all desired channels, tighten all bolts. See drawings A and B. To display the
signal and quality readings press the “INFO” button on the remote control.
Please now check again as to whether you are receiving the set programme on the
receiver and continue to switch channels on the receiver with the remote control CH+
and CH- buttons.
If you have no reception after carefully going through the process or if other faults oc-
cur, please contact your specialist dealer.
Note: This installation method requires 2 people.
Now turn your dish slowly to the east (left) while watching your TV set, until the recep-
tion part is pointing directly east, that is, turn it through 90 degrees. See Fig.03.
Fig.03
With digital satellite reception the receiver receives the transmitter signal with a
slight time lag. Therefore turn the dish very slowly and wait at each position for a
few seconds, until the receiver displays the signal strength on the screen menu.
When you have aligned your satellite dish to the correct location and you are receiving
the desired satellite channels, lock the dish off to stop it moving.
Aligning the Satellite Dish Continued
Содержание SR 110
Страница 1: ...Triax SR 110 Digital Satellite Receiver Operating Manual 305112...
Страница 5: ...5 Remote Control...