Triax SR 110, Руководство по эксплуатации

Страница: 17 / 50

34
Installation Symbol: Satellite Dish
Submenu Description
Satellite Satellite selection, Example: Astra1 19° East)
LNB type
Select LNB type (Standard setting is Universal)
22 KHz
Activating 22 KHz Note: with LNB type Universal the
activation is automatic
DiSEqC Select DiSEqC level
DiSEqC
Switch
Select DiSEqC command
Example:
Astra and Hotbird double reception
Astra = 1 / 4
Hotbird = 2/ 4
Deactivate for controlling the motor (invalid)
Positioner You can access the DiSEqC motor control menu via
the OK key. Please consult the operating guide of
your DiSEqC motor.
Polarity
Horizontal, Vertical, H/V (Automatic)
TP Scan (manual
channel search run)
With this search function, you can search the pre-set frequen-
cies (transponder) individually. The transponder data can be
changed manually.
This process is started using "Search".
Preset Scan Searching through pre-programmed frequencies (transponder).
(Normal automatic search run)
Auto Scan
(unique function, can
be carried out without
any prior knowledge), Here, you can search completely through a selected satellite
(example:Astra1 19° East) for new programmes. No particular
details are required for this. You can choose to search for free or
all TV and radio programmes.
This process is started using "Search".
Particularly recommended for Türksat
17
Satellite Cable fitting Instructions
Fitting the Satellite Cable
(Assembly diagram on the following page)
For fitting the F-connector onto the coaxial cable you need wire strippers and
wire-cutting pliers.
Cut 8 mm of coaxial cable at each end down to the inner core.
Carefully strip 10 mm of the outer insulation off, so that the braiding is free.
Push the braiding back over the outer insulation, so that it is not
touching the inner wire.
Remove the inner dielectric up to 2 mm in front of the braiding
Twist the F-connector onto the braiding, until the connector comes up against the
inner insulation.
There must be no braiding overlapping at the back of the connector end.
Shorten the inner core with wire-cutting pliers, so that it protrudes a maximum of 1 mm
out of the connector.