Triax SR 110, Руководство по эксплуатации

Страница: 24 / 50

24
First step:
Switch your TV set on. Please take care that your TV set is adjusted to the receiver.
With a SCART connection the TV set must be on the appropriate AV
channel.
Second step:
Now switch the receiver on. Please note in doing this that the receiver is
pre-programmed for the most common satellites and their programmes and that you
only have to enter the channel numbers via the number pad on your receiver remote
control:
Example:
If you want to receive the Astra 19.2° East satellite, you must put your receiver onto
channel 1 to align the dish. The same also applies for other satellites such as
Hotbird. If you wish to align your aerial to Hotbird, you must call up a pre-programmed
Hotbird channel on your receiver.
Third step:
Now align your dish with the satellite you have selected. There are several possibilities
for doing this. The simplest method is as follows:
Fig.01
Azimuth—Left or Right
Fig.02
Aligning the Satellite Dish Continued
27
Caution!
Check the proper connection of all devices and the dish, before you connect the
receiver to the mains power supply.
Insert the mains plugs of the connected devices into the mains power socket and
switch the connected devices on.

Switch the AV channel on the TV set on.

Insert the receiver’s mains plug into the mains power socket.
On the back of the receiver, turn on the mains switch.
The device will be in normal mode. The current channel
position will be displayed.

The receiver is supplied with pre-programmed television
programmes and can be used immediately. If you want
to establish whether there are new programmes, activate
a programme search scan. For this, read the information
below.
Standby mode, press the red button on the top right of the remote control. The current
time is displayed. The device only consumes around 2 watts in Standby mode.
Receiver