TRENDnet TEG-S2620is, Руководство пользователя, Страница: 46 / 124

the manager personal, he/she can save the time and easily on switches
controlling.
„
MAC Address Ageing Time:
MAC address table refresh time setting. Type
the number of seconds that an inactive MAC address remains in the switch’s
address table. The valid range is 0, 300~765 seconds. Default is 300
seconds.
„
Broadcast Storm Filter mode:
configure the broadcast storm filter mode.
The valid threshold values are 5%, 10%, 15%, 20%, 25%, and N/A. The port
will be block cause of broadcast packet is over the percentage of traffic.
„
Max Bridge Transmit Delay Bound:
Limit the packets queuing time in
switch. If enable, the packets queued exceed will be drop. Press
Space
key
to set the time. This valid value are 1sec, 2sec, 4sec and off. Default is off.
„
Low Queue Delay Bound:
Limit the low priority packets queuing time in
switch. If enable, the low priority packet stays in switch exceed Low Queue
Max Delay Time, it will be sent. Press
Space
key to enable or disable this
function.
„
Low Queue Max Delay Time:
To set the time that low priority packets
queuing in switch. Default Max Delay Time is 255ms. The valid range is
1~255 ms.
NOTE:
Make sure of “Max bridge transit delay bound control” is enabled before
enable Low Queue Delay Bound, because Low Queue Delay Bound must be work
under “Max bridge transit delay bound control” is enabled situation.
„
Collisions Retry Forever:
Disable – In half duplex, if happens collision, the
switch will retry 48 times and then drop frame. Enable – In half duplex, if
happens collision, the switch will retry forever
„
Hash Algorithm:
This Hash Algorithm is for hardware maintaining on the
MAC table calculation. Provide CRC or Direct Map.
„
IFG compensation:
Disable or Enable.
„
IP Stacking Group ID (0…65535):
assign the stacking group ID. The
switches must assign the same stacking group ID to be stacked as a group.
„
IP Stacking Mode:
enabling/disabling the stacking function. There are three
stacking modes. Any port on the switch can be used to stack. To configure
40