TRENDnet TEG-S2400I - DATA SHEETS, Руководство пользователя, Страница: 11 / 149

- 11 -
Default gateway, under this condition, you can execute your browser program in your PC and simply
type http:// IP-Address-of-switch to access the switch through Ethernet or over internet. But if there
is no DHCP in the network, then you must follow the steps instructed below:
Fourth, Webpage login will prevent attacks from hackers. If user continually fails in login for 3 times,
http authentication will reject any http request until 3 minutes later.
When there is no DHCP server in your network domain, according to the concept described above,
you must modify either the PC side or switch side to match the rule “the communication members in
the same domain must have different IP Addresses and same Subnet Mask. “, below, we try to state
the steps if we modify the content of IP configuration within the switch to match the domain
requirement of the PC:
Step 1 : Get the IP configuration information in your PC
Step 2 : Get IP configuration value used for switch from your network manager.
Get an IP Address for your switch, get IP Subnet Mask, and get default gateway IP address (if needed)
from your network manager.
Step 3 : Modify the IP configuration value within the switch to match the rule
In the step 3, you must use the data that get from step 2 to modify the default value within the switch,
to achieve this, use terminal mode operation mentioned in 1.3.1. After modifying the IP address,
Subnet Mask, Default Gateway in the switch, then save the setting and execute the browser program
with http:// IP_Address_ of_ switch, then you may access the switch with following dialogue below.
Then type user name and password to get further service. To find out more operation in this mode,
please refer the instructions in chapter 3 of this manual to perform all function you want.