TREND CRT MK2, Руководство пользователя

Страница: 22 / 38

-21-
CRT MK2
Grooving with the Back Fence
The router table can be used for operations
away from the edge of the workpiece such as
grooving, fluting, veining, etc.
When routing, always feed against the rotation of
the cutter. This direction is marked on the back
fence.
For maximum accuracy, one edge of your
workpiece (the edge sliding against the fence)
must be true and straight.
Set up the back fence as follows:
■
Raise safety guard and rest it
against the extraction point.
■
Position the fence behind the router bit for the
desired cutting depth (the distance of cut
from the edge of the workpiece).
■
Securely tighten back fence fixing bolts and
lower the guard over the cutter.
■
Make the cut by sliding the straight edge of
workpiece against the fence. Use the
pushstick as shown.
Full edge moulding using the
Workpiece Support
The workpiece support can be used to plane an
edge.
■
The cutter should be set approximately 2mm
proud of the back fence.
■
The workpiece should be routed until the
planed edge passes onto the out-feed fence.
■
Retract workpiece away from cutters and
switch off router.
■
Replace workpiece and bring workpiece
support out until it touches.
■
Tighten knob and continue routing.
IMPORTANT!
Never push small or narrow
workpieces by hand past the
router cutter, unless a jig or
pushstick/pushblock is used.
Always work with the guard
lowered.
Adjust the cutting height and
depth only when the power has
been isolated and the router
cutter stops rotating.