TREND CRT MK2, Руководство пользователя

Страница: 24 / 38

-23-
CRT MK2
w
w
Tenon Cutting using the Push Tenon
Block
The tenon push block facility is ideal for
producing tenons and sliding dovetails.
IMPORTANT!
The retractable guard cannot be
used when carrying our push
block operations. Therefore
extra care must be taken to
ensure that hands are kept well
clear of the cutter.
■
Ensure that the workpiece is true and the end
is square and smooth.
■
Mount push block assembly on the back
fence.
■
Adjust the height and depth of the cutter to
suit the cut required.
■
Position workpiece between clamp plate and
push block so that it's side is flush against the
face of the back fence, and the end to be cut
is resting on the table. Clamp workpiece in
this position by tightening the wing nut on the
clamp rod while making sure that clamp plate
stays orientated on the workpiece.
■
Slide push block and workpiece back to the
start position. When routing, always feed
against the rotation of the cutter.
■
Switch router on and guide the push block
against the back fence with both hands,
keeping fingers at a safe distance from cutter.
■
Switch router off, unclamp workpiece and
slide push block back to its original position.
■
Position and re-clamp each side of workpiece
and repeat cutting operations.
Useful advice.
When setting up, a piece of paper placed
between the compact and table top will give
sufficient gap to slide properly.
A scrap piece of timber should be placed behind
the workpiece to prevent break-out.