TREND CRT MK2, Руководство пользователя

Страница: 17 / 38

-16-
CRT MK2
Profiling Top Guard - CRT/2
■
Remove the back fence and assemble the
profiling top guard as shown.
The use of the optional profiling top guard is
recommended when profiling of workpieces
workpieces with a pin or ball bearing guided
cutter. It will prevent the operator's fingers
inadvertently contacting the cutter while
providing good visibility.
Pages 26 and 27 describe a typical application
involving using ball bearing guided cutters with
to make a shield.
Spring Pressure Clamps - CRT/10
The optional spring pressure clamps can be
mounted to the back fence. When adjusted to
suit the width and thickness of the workpiece,
they ensure the workpiece is held down onto
the surface to obtain accurate machining of
the workpiece.
■
Remove back fence from table surface
and assemble as shown.
Adjustment
■
The spring pressure clamps will require
adjusting to suit the height and width of
workpiece being routed.
■
The pressure strips should provide enough
pressure to prevent the workpiece lifting
from the table surface, but not too much
as to create friction which would prevent
the workpiece from sliding freely.
■
The horizontal bar with pressure strip fitted
can be removed from the vertical pillars
when not required. The vertical pillars can
be left in position and will not impede the
tenon push bock system.
CRT/10
CRT/2