Threat Protection System Hardware Specification and Installation Guide
21
Installing the TPS device
After you have completed preparation procedures and unpacked the TPS device, you are ready to install
and configure the components. Have the
CLI Reference
available for configuration information reference.
After installation of the hardware components, complete the OBE Setup Wizard requirements as part of the
installation and configuration procedures.
Note:
Before installing your device, review and adhere to all safety guidelines described the
Hardware Safety
and Compliance Guide
, which also contains detailed regulatory compliance information and is included
with your product shipment.
This information includes the following procedures:
•
Install the chassis
on page 21
•
Connect the power supply
on page 28
•
Attach cables
on page 28
•
Check LEDs
on page 29
•
Run the setup wizard
on page 29
Install the chassis
Before installing your new security device, gather any necessary materials and prepare the network and
hardware site. To carefully and correctly install the device, read through all preparation instructions and
requirements. This information provides general guideline information for all TippingPoint devices.
To install the device you must do the following:
•
Determine total rack space
on page 21
•
Attach the device to the rack
on page 22
•
Connect the power supply
on page 28
Determine total rack space
Before you install the chassis, determine the total rack space that is required to install your system. The total
required rack space increases if you plan to install multiple systems.
The device fits in a 19-inch-wide rack (or a 23-inch-wide rack, with appropriate conversion parts available
from rack accessory vendors). For more information about the dimensions of the device, refer to the
technical specifications and requirements for your model.
