28
Threat Protection System Hardware Specification and Installation Guide
Connect the power supply
Describes how to get power to your device.
1. After you have bolted the device to the rack, attach the power supply AC connections.
2. To turn power on for the 440T device, flip the power switch on the back panel of the device.
3. To turn power on for the 22000T device, use the power button located on the front panel of the device.
Attach cables
During initial setup, use the management processor connection or the console port to access the setup
wizard.
Attach the Console port connection
Describes how to attach the console port connection.
1. Connect the RJ-45 null modem cable to the Console port on the front of the unit.
2. Connect the other end of your cable (standard-sized female DB-9 connector) to your VT100-compatible
terminal or your computer.
Use the following terminal settings for the Console port:
• Baud rate: 115.2 Kbps
• Character size: 8 bits
• Parity: None
• Stop Bits: One
• Flow Control: None
Attach the management processor connection
Describes how to attach the management processor connection.
1. Connect one end of the Category 5 Ethernet cable to the port labeled MGMT located on the front
panel.
2. Connect the other end of the Ethernet cable to your network. This enables remote management.
Attach network connections
Describes how to make network connections.
