Installation
(for qualified installers only)
19
© Travis Industries
4100519
100-01197_001
Steps for Installing the Battery Pack and Wall Switch
1. Remove the control cover and attach the 12’ long battery box wire to the quick connects on the receiver
module (see Figure 12 below). Route the battery box wire through the opening below the cover. At this
time make sure the continuous pilot switch is set to “OFF” and the remote switch is set to “REMOTE” on the
receiver module – item “a”). You may also wish to verify all the wire leads are fully attached.
POWER
MOTOR
Learn
Continuous
Pilot
Off/On
Remote/Off
ADJ
S
I
Motor Wires (for flame height adjustment)
Red, Yellow, White, and Blue wires
White
Green
Orange
White
Main Burner Control Wires
Pilot Flame Control Wires
Sensor ("S")
Wire (White)
Brown Switch
Wires (not
used)
Battery Box
(external junction box)
Gas Control Valve
Receiver
Module
Pilot Assembly
Make sure continuous pilot
is set to "OFF" and remote
is set to "REMOTE".
a
Igniter ("I") Wire
(Orange - with
fiberglass
insulation)
AC Adapter
(wire orientation does not matter)
COMM.
Black
Ground
Battery Wires
Red and White Wires
Learn Wires
Two White Wires
Figure 12
2. Determine a location for the single-gang junction box that contains the battery pack and learn switch. It
must be located within 12’ of the fireplace. Mount the junction box.
3. Insert the battery box wires through the junction box, leaving approximately 8” of slack so the battery pack
may be removed and the batteries replaced. Use a staple or other means to secure the wiring to the
framing – this prevents the wires from slipping out of the junction box in the event the wires become
disconnected from the battery pack (see
Figure 11
). NOTE: The wiring is low-voltage (6V) and does not
require a strain relief. Connect the learn switch and battery pack wires (see
Figure 12
).
4. Place batteries inside the battery pack and place it inside the junction box. Attach the remote holder to the
junction box with the included screws.
INSTALLATION WARNING – Remote Synchronization
At this time we highly recommend you verify the remote and fireplace are synchronized. This
process requires access to the learn switch. See the instructions on page 20 for details.
Battery Installation
This fireplace uses four AA batteries for operation during power outages. Place the batteries into the battery
box. In addition, two AAA batteries are required for the transmitter.
