CATALOGUE
INTRODUCTION
INTRODUCTION
1
Safety information
LCD display signal
Monitor components
BEFORE YOU START
4
The Choice of power supply
Installing and replacing the batteries
Setting Date, time and measurement unit
MEASUREMENT
7
Tie the cuff
Strat a measurement
THE OPERATION OF RECALLING RECORDS
9
Recall the records
Delete the records
INFORMATION FOR USER
11
Tips for operation
Maintenances
ABOUT BLOOD PRESSURE
13
What are systolic pressure and diastolic pressure?
What is the standard blood pressure classification?
Why does my blood pressure fluctuate throughout the day?
Why the blood pressure I get from the hospital is different from
home?
If the result is the same if measuring on the right wrist?
TROUBLESHOOTING
15
SPECIFICATIONS
16
CONTACT INFORMATION
17
The below signs might be in the user manual, labeling or other component.
They are the requirement of standard and using.
Safety information
This device is intended for adult use only.
This device is intended for no-invasive measuring and monitoring of arterial blood pressure. It is
not intended for use on extremities other than the wrist or for functions other than obtaining a blood
pressure measurement.
Do not confuse self-monitoring with self-diagnosis. This unit allows you to monitor your blood
pressure.Do not begin or end medical treatment based solely physician for treatment advice.
If you are taking medication,consult your physician to determine the most appropriate time to
measure your blood pressure. Never change a prescribed medication without consulting your
physician.
This unit is not suitable for continuous monitoring during medical emergencies or operations.
If the cuff pressure exceeds 40 kPa (300 mmHg),the unit will automatically deflate. Should the cuff
not deflate when pressures exceeds 40 kPa (300 mmHg),detach the cuff from the wrist and press
the START/STOP button to stop inflation.
To avoid measurement errors, carefully read this manual before using the product.
The equipment is not AP/APG equipment and not suitable for use in the presence of a flammable
anesthetic mixture with air of with oxygen or nitrous oxide.
The operator shall not touch the battery and the patient simultaneously.
The user must check that the equipment functions safely and see that it is in proper working
condition before being used.
The manufacturer does not require such preventive inspections by other persons.
The Max. temperature of apply part can be achieved is 42.5
℃
under the environmental
temperature of 40
℃
.
Manufacture will make available on request circuit diagrams, component part list, etc.
CAUTION
Caution:Consult accompanying
documents
CE Mark: conforms to
essential requirements of the
Medical Device Directive
93/42/EEC.
Manufacturer
Specifies serial number
Type B applied part
Direct current
D I S P O S A L : D o n o t d i s p o s e t h i s
product as unsorted municipal waste.
Collection of such waste separately
for special treatment is necessary.
Authorized Representative in
the European Community
EC
REP
Thank you for selecting TRANSTEK wrist blood pressure Monitor (TMB-1014-BT).
The monitor features blood pressure measurement, pulse rate measurement and
auto-save the result. The design provides you with many years of reliable service.
Reading taken by the TMB-1014-BT are equivalent to those obtained by a trained
observer using the cuff and stethoscope auscultation method.
This manual contains important safety and care information, and provides step by
step instruction for using the product.
Read the manual thoroughly before using the product.
Features:
Systolic blood pressure
Diastolic blood pressure
Pulse rate
Historic record of up to 60 measurements
