Page 5-5
4. When the control code is highlighted, press the Edit soft key. The scale
prompts for a new control code.
5. Use the numeric keys to enter in the new control code in decimal (1-255).
6. Repeat Steps 3 through 5 until all control codes are edited.
7. Press the Done soft key to exit and save changes.
5.2.2.6
RESTORE DEFAULTS (Deflt)
This function allows you reset all print format parameters back to the factory
default. Default settings will vary depending on the type of printer selected in
Section 5.3.5.
Use with extreme caution – this process cannot be undone!
1. Enter the Print Format sub-menu as described above.
2. Press the Deflt soft key. The scale automatically restores the default settings
and returns to the Print Format sub-menu screen.
5.2.3 SETTING THE SYSTEM CLOCK SUB-MENU (CLOCK)
This function is used to set the current date and time into the scale. Although you may
choose any format to print the time and date, you must program the date using standard
format and the time using military (24 Hr) format.
1. Enter the Supervisor Menu as described above. The scale prompts for the area to
setup.
2. Press the Clock soft key. The scale displays the current time and date settings. A
flashing cursor appears in the date field.
3. If the date is correct, press the ENT key to move to the time field. Otherwise, use the
numeric keys to key-in the current date in Standard (mm/dd/yy) format. For example,
for January 7, 2000 you would enter 010700. For November 30, 2000 you would enter
113000. There is no need to press the ENT key. The flashing cursor moves
automatically to the time field.
4. If the time is correct, press the ENT key. Otherwise, use the numeric keys to key-in the
current time in 24-Hour (Military) format. For example, for 9:00 AM you would enter
090900. For 5:00 PM you would enter 170000. (The last two digits are the seconds).
There is no need to press the ENT key. When the time is entered, the flashing cursor
disappears.
5. Press the ENT key to save the changes and exit this sub-menu.
5.2.4 ITEM ID SUB-MENU (ItemID)
This function is used to list, print or erase all items stored in the scale.
1. Enter the Supervisor Menu as described above. The scale prompts for the area to
setup.
2. Press the ItemID soft key. The Configuration sub-menu items are listed above the six
soft keys.
