Trane MCD 048, Руководство по установке и эксплуатации

Страница: 22 / 28

22 SS-SVX07B-E4
Operation
Auto (optional)
The unit can be put into 5 different
modes (FAN, COOL, DRY, HEAT and
AUTO). The cycling will be:
➠
FAN
➠
COOL
➠
DRY
➠
HEAT
➠
HEAT
➠
AUTO
➠
When the system is in AUTO mode,
the display on the remote controller
will show COOL and HEAT modes at
the same time.
Louver (optional)
To change the angle of the louver: if
the button is pressed and released,
the angle of the louver is changed
one step at a time. If the button is
pressed and held, the angle of the
louver is changed until the button is
released.
Sleep mode
For COOL mode, the setting
temperature will be automatically
raised 1°C after 1 hour. For HEAT
mode, the setting temperature will
be automatically lowered 1°C after 1
hour.
When the system is in SLEEP mode,
pressing the SLEEP button will
cancel the SLEEP function. When
the system is in SLEEP mode,
pressing the TEMP button will raise
the setting temperature 1°C from the
last setting.
When the system is in SLEEP mode
and the unit is stopped by a power
failure or is turned off, the SLEEP
function will be canceled.
Wireless controller
operation
To use the wireless controller, point
the transmitter head directly towards
the unit receiver to emit infrared
signals.
Figure 13 - Wireless controller
1. Operating mode
2. Fan speed
3. Fan button
4. Sleep button
5. Mode button
6. Sweep button - to turn on/off the sweep
motor
7. Louver button
8. Timer (start) button
9. Send button - to transmit all parameters
shown on the LCD to the main control
board
10. Clock
11. Timer (start/stop)
12. Transmit mode (lit when remote is being
used)
13. Sleep mode
14. Temperature (range: 16-30°C)
15. Power button
16. Temperature setting button
17. Stop button
18. Clock setting button
19. Minute setting button
20. Hour setting button
SLEEP MODE
SWEEP LOUVER
HOUR
START
SEND
TEMP
STOP
MIN
FAN
COOL
DRY
HEAT
10:14
18:40
6:30
START
STOP
HIGH
MED
LOW
AUTO
Clock
To set the clock:
- Press the clock setting button
(Figure 13, 18). The time display
will blink.
- Press the HOUR button to set the
hour. (Figure 13, 20)
- Press the MIN button to set the
minutes. (Figure 13, 19)
- Press the clock setting button
again. The time display will stop
blinking.
Auto start
The unit can be programmed to start
automatically. To program:
- Press the START button. (Figure
13, 8) The time display will blink.
- Press the HOUR button to set the
hour. (Figure 13, 20)
- Press the MIN button to set the
minutes. (Figure 13, 19)
- Press the START button again. The
time display will stop blinking.
Auto stop
The unit can be programmed to stop
automatically. To program:
- Press the STOP button. (Figure 13,
17) The time display will blink.
- Press the HOUR button to set the
hour. (Figure 13, 20)
- Press the MIN button to set the
minutes. (Figure 13, 19)
- Press the STOP button again. The
time display will stop blinking.