Trane Foundation GCC180-300, Установка, эксплуатация и обслуживание

Страница: 17 / 52

RT-SVX51L-EN 17
Rigging
WARNING
Heavy Object!
Failure to follow instructions below could result in
unit dropping which could result in death or serious
injury, and equipment or property-only damage.
Ensure that all the lifting equipment used is properly
rated for the weight of the unit being lifted. Each of the
cables (chains or slings), hooks, and shackles used to
lift the unit must be capable of supporting the entire
weight of the unit. Lifting cables (chains or slings)
may not be of the same length. Adjust as necessary
for even unit lift.
WARNING
Improper Unit Lift!
Failure to properly lift unit in a LEVEL position could
result in unit dropping and possibly crushing
operator/technician which could result in death or
serious injury, and equipment or property-only
damage.
Test lift unit approximately 24 inches (61 cm) to verify
proper center of gravity lift point. To avoid dropping of
unit, reposition lifting point if unit is not level.
Refer to Figure 12, p. 17 and , p. for typical unit
operating weights rigging before proceeding.
1. Remove the shipping crate from around the unit. Once
fork trucking is complete, and unit is ready to place on
the curb, remove all fork access brackets to drop the
shipping boards from underneath the unit (4 brackets
standard forking, 6 brackets for 3 sided forking). Do not
remove the crating from the top of the unit.
2. Rig the unit as shown in Figure 12, p. 17 . Attach
adequate strength lifting slings to all four lifting brackets
in the unit base rail. Do not use cables, chains, or slings
except as shown.
3. Install a lifting bar, as shown in Figure 12, p. 17 , to
protect the unit and to facilitate a uniform lift. The
minimum distance between the lifting hook and the top
of the unit should be 7 feet.
4. Test-lift the unit to ensure it is properly rigged and
balanced, make any necessary rigging adjustments.
5. Lift the unit and position it into place.
6. Downflow units; align the base rail of the unit with the
curb rail while lowering the unit onto the curb. Make
sure that the gasket on the curb is not damaged while
positioning the unit.
Figure 12. Rigging and center of gravity data
CENTER OF GRAVITY
LENGTH
CENTER OF GRAVITY
WIDTH
Weights