www.TrailFX.com
Page
5
of
7
Rev R01; 121020
5.
Move to the rear location,
(Figure 16)
. Repeat
Steps 2
—4
to install the rear Brackets,
(Figure 17)
.
NOTE
: The cradles on the
front, center and rear Brackets must all face forward.
6.
Select the driver/left Sidebar. Carefully position the Sidebar onto the (3) Mounting Brackets.
IMPORTANT
: Do not slide, (front to
back or rotate), the Sidebar on the Brackets or damage to the finish on the Sidebar may result. Attach the Sidebar to the (3)
Brackets with (6) 8mm Combination Hex Bolts,
(Figures 18
—20)
. Do not fully tighten at this time.
Rear
(Fig 16) Driver/Left rear mounting location
IMPORTANT: 2009-2012 models without holes
in pinch weld will require drilling 1/4” holes
through pinch weld to attach driver side front
support bracket. Do complete installation of
sidebars first, level sidebar before drilling
holes for support bracket.
Rear
(Fig 17) Driver/Left rear Brackets installed
IMPORTANT: 2009-2012 models without holes
in pinch weld will require drilling 1/4” holes
through pinch weld to attach driver side front
support bracket. Do complete installation of
sidebars first, level sidebar before drilling
holes for support bracket.
Front
(Fig 19) Driver/left center installation
(2) 8mm Combo
Hex Bolts
(Fig 14) Driver/left center and rear Brackets,
note same as passenger/right front Brackets
Front
Front
(Fig 18) Driver/Left front installation
(2) 8mm Combo
Hex Bolts
Front
(Fig 15) Attach Driver/Left center Bracket
