www.TrailFX.com
Page
4
of
7
Rev R01; 121020
Models with factory threaded inserts:
a.
Attach the driver side Front Bracket directly to the threaded inserts with (2) 8mm x 30mm Hex Bolts, (2) 8mm Lock
Washers and (2) 8mm Flat Washer,
(Figures 9 & 10)
. Leave hardware loose.
3.
Next, select a driver side Support Bracket. Attach the Bracket to the back of the front Bracket with (1) 8mm x 30mm Hex Bolt,
(2) 8mm Flat Washers and (1) 8mm Nylon Lock Nut,
(Figure 11)
. Rotate the Support Bracket to the back of the pinch weld.
Line up the slots in the top of the Support Bracket with the (2) factory holes in the pinch weld. Attach the Bracket to the back of
the pinch weld with (2) 6mm x 25mm Hex Bolts, (4) 6mm Flat Washers and (2) 6mm Nylon Lock Nuts,
(Figure 12)
. Do not fully
tighten hardware at this time.
IMPORTANT
: 2009-10 models are not equipped with factory holes and will require drilling through
the pinch weld to attach the Support Bracket. Do not drill through pinch weld at this time, (
see Step 8
).
4.
Move along the side of the body panel to the center mounting location,
(Figure 13)
. Repeat
Steps 2
—4
to install the driver side
center Bracket and Support Bracket,
(Figures 14 & 18)
.
Front
(Fig 9) Driver side front mid 2015-on, an example of
models with factory installed threaded inserts
Front
(Fig 13) Driver/Left center location
Front
(Fig 10) Driver side front-models with factory
installed threaded inserts. Bolt Plate not required
(2) 8mm Hex Bolts
(2) 8mm Lock Washers
(2) 8mm Flat Washers
Front
(Fig 11) Attach Support Bracket
to back of Mounting Bracket
8mm Hex Bolt
(2) 8mm Flat Washers
8mm Nylon Lock Nut
Front
(Fig 12) Attach Support Bracket to back of pinch
weld (models with holes in pinch weld only)
(2) 6mm Hex Bolts
(4) 6mm Flat Washers
(2) 6mm Nylon Lock Nuts
IMPORTANT: Driver/left side center and
rear Brackets are the same as
passenger/right front Brackets (see Fig 14)
