www.TrailFX.com
Page
2
of
7
Rev R01; 121020
INSTALLATION PROCEDURE
1.
Starting at the driver side-front of the vehicle, remove the sealing tape covering the factory holes in the side of the inner panel,
(Figure 1)
.
2.
Determine the correct procedure to attach the driver side front Bracket for your model/year:
Models without factory threaded inserts in body panel:
a.
Partially thread an 8mm Hex Bolt into the threaded end of an 8mm Bolt and Nut Plate,
(Figure 2)
. Thread the Hex Bolt in
until it is flush with the welded nut,
(Figure 3)
. Use the Hex Bolt as a handle and insert the Bolt and Nut Plate into the oval
hole,
(Figure 4)
.
b.
Feed the threaded bolt on the Bolt Plate through one of the hex shaped factory holes.
Front
(Fig 1) 2009-mid 2015 Driver/Left front
mounting location (No factory holes
in pinch weld on 2009-2011 models)
(Fig 2) 8mm Bolt-8mm Nut Plate, NOTE:
8mm Bolt-Nut Plate is not required on
models with threaded inserts
(Fig 3) Thread (1) 8mm Hex Bolt
into the nut on the plate. Stop when
bolt reaches end of nut as pictured
Fig 4
Use the loose Hex Bolt as a handle. Insert
the Bolt Plate into the oval hole and feed the
threaded end out either factory hex shaped
hole. IMPORTANT: Do not let go of the hex
bolt until after Plastic Retainer has been
threaded onto bolt (Fig 5)
