www.TrailFX.com
Page
3
of
7
Rev R01; 121020
c.
Thread (1) 8mm Plastic Retainer onto the threaded end and down tight against the body panel,
(Figure 5)
.
NOTE
: The
Plastic Retainer is designed to keep the Bolt/Nut Plate from falling into the body panel and to aid in Bracket installation.
d.
Select a driver side Mounting Bracket,
(Figure 6)
. Attach the Bracket to the threaded end of the Bolt Plate with (1) 8mm
Flat Washer, (1) 8mm Lock Washer and (1) 8mm Hex Nut,
(Figure 7)
. Do not tighten at this time.
e.
Remove the 8mm Hex Bolt from the nut on the Bolt Plate from
Step 3a
. Rotate the Bolt on the Bolt Plate until the threaded
nut lines up with the remaining hole in the Mounting Bracket and body panel,
(Figures 7 & 8)
. Attach the Bracket to the
threaded Nut Plate with (1) 8mm x 30mm Hex Bolt, (1) 8mm Lock Washer and (1) 8mm Flat Washer,
(Figure 8)
. Do not
fully tighten hardware at this time.
(Fig 5) Thread Plastic Retainer onto Bolt
Plate to hold Bole Plate in position.
Plastic Retainer
(Fig 6) Driver side front Brackets, note same
as passenger/right center and rear Brackets
Front
Front
Remove Hex Bolt, rotate Bolt/Nut
Plate to line up threaded nut with
body panel and Mounting
Bracket (see arrow)
8mm Flat Washer
8mm Lock Washer
8mm Hex Nut
Plastic Retainer
(Fig 7) Attach Bracket to Bolt on Bolt Plate
Front
Fig 8
8mm Hex Bolt
8mm Lock Washer
8mm Flat Washer
Attach Bracket to threaded end of Bolt
Plate first. Remove 8mm Hex Bolt (see
Fig 3). Rotate Bolt Plate to line up with
remaining factory hex shaped hole.
