TRADEDX SSR-4N108L, Руководство пользователя

Страница: 68 / 85

Configuration
Chassis Management Module (CMM)
IP Address
The CMM FW can be configured using Static or DHCP IP address settings. Set the IP address
by using the system management software --default setting is DHCP.
Username and Password
A username and password are required to establish a session. The user should also
have ac- cess to the same LAN subnet. Use the system management software to set
the username, password, and privileges. The default setting is shown below:
Username: admin
Password: admin
Updating the CMM Firmware
Many common problems can be resolved by updating the firmware. The CMM FW
can be up- dated through the
Yafuflash host-based utility.
CMM FW Version
Normally, the end user must check the FW version before starting operations. By
using the standard IPMI command in the ipmitool utility, you can obtain CMM FW
information.
Command:
#ipmitool –H <ip address> -U <username> -P <password> -I lanplus mc info
Example:
[root@localhost]# ipmitool -H 10.67.222.129 -U admin -P admin -I lanplus mc info
Device ID
: 32
Device Revision : 1
Firmware Revision : 1.00
IPMI Version : 2.0
Manufacturer ID : 0
Manufacturer Name : Unknown
Product ID : 514 (0x0202)
Product Name : Unknown (0x202)
Device Available : yes
Provides Device SDRs : no
Additional Device Support :
Sensor Device
SDR Repository Device SEL
Device
FRU Inventory Device IPMB
Event Receiver IPMB Event
Generator Chassis Device
Aux Firmware Rev Info:
0x00
0x00
0x00
0x00