TRADEDOR TD55DM, Руководство по установке

Страница: 13 / 40

Tradedor TD55DM & TD55SEL Installation Guide
Direction Of Rotation (Hold To Run)
1 Press and hold the bottom button ( ) on the handset and the barrel should start turning in the
downwards direction. Should the barrel be turning in the up direction, press the middle stop button
( ) so the barrel stops and then move the left of the three dip switches up
(fig.6.2 A) .
2 Press and hold the bottom button ( ) on the handset, and the barrel should start turning in the
downwards direction.
3 Press and hold the right-hand button
( )
on the front of the receiver box and the barrel should start
turning in the downwards direction. Should the barrel be turning in the up direction, press the middle
button ( ) on the front of the receiver box so the barrel stops and then move the right of the three
dip switches up
(fig.6.2 C) .
4 Press and release the down button
( )
. If the door closes, press the stop button and flick the middle
dip switch up (fig.6.2 B) . You should now have to press and hold the down button for the door to close.
Deleting Remote Control Handset’s Memory
1 Press and hold the black programming button for roughly 3 seconds. The green LED will
flash three times, go solid, then rapidly flash. Keep hold until flashing stops.
2 Test to see if remote operates door.
1 Re-attach the front box cable to the board.
2 Press and hold the bottom button ( ), if the door
moves then the handset is already programmed in.
Repeat with all other handsets.
3 If not programmed then press and release the black
programming button located at the top of the receiver
box
(fig.6.2) . The green LED on the front cover will
start flashing.
4 Press and hold the top button on the handset ( ).
The green LED will flash faster and go out.
5 Test handset by pressing either direction, the barrel
should move. Repeat with all other handsets that
need programming.
fig.6.1
fig.6.2
A B C
12
7. Programming Remote Control
Handsets & Push Button
(HOLD TO RUN)
- TYPE 2