TRADEDOR TD55DM, Руководство по установке

Страница: 8 / 40

Tradedor TD55DM & TD55SEL Installation Guide
1 Place your hop ups / step ladders and one
guide runner each side of the opening.
2 If you have a safety edge system on your
door then you will need to remove the
securing screw.
3 With one person each end, lift the header
assembly by the header plate up and into
place, then guide the locating stem at each
end into the hollow section of guide runners
(this can be made easier by slightly angling
the header if there is not enough room to
simply drop the locating stem in)
(fig.3.1) .
4 Lift the whole unit flush into place and check
that the top box and guide runners are plumb
level and square
(fig.3.2 & fig.3.3) .
5 Drill a 7mm fixing through the top hole in
the guide runners and secure into place
(fig.3.4) .
6 Check the case and guide runners are
still level and square, then proceed to drill
a 7mm fixing through the remaining holes,
remembering to check the guide runners
are square and plumb after each fixing.
7 Check to make sure all fixings have not
caused the front fascia to be pulled in,
as this will rub against the slats causing
damage and scratching to the face.
8 Making sure 1 person is holding the back
case in place remove any screws from
each end and keep safe for later, then lift
the backcase up so it can be removed to
expose the curtain of the door.
9 (For Internal Manual Override system)
Remove winding stem from your winding
handle where it has been taped securely.
10 (For External Manual Override system)
remove metal shaft via the plastic circlet
(p.34,
fig.15.1, number 4 ) .
fig.3.1
fig.3.3
fig.3.2
fig.3.4
11 Remove screw from end of stem and keep
safe for later.
12 Cut cable ties and release curtain, and place
available curtain into guide rails through the
mouth of the guides.
13 Insert winding stem through pre-drilled hole
in header plate. Turn to release more curtain
into guides, roughly 4 slats in total, remove
winding stem and keep safe for later.
7
3. Installing Header Assembly