TRADEDOR TD55DM, Руководство по установке

Страница: 11 / 40

Tradedor TD55DM & TD55SEL Installation Guide
Direction Of Rotation
(HOLD TO RUN)
1 Press and hold the right ( ) button on the handset and the door should start moving in the downward
direction. Should the barrel be turning in the upwards direction press the stop button ( ).
2 Swap the black and brown motor wires round in the green motor connection block.
3 Re-attach the membrane ribbon to the pcb board on to the 4 pins on the top right (fig.5.2) .
4 Press and hold the down button and the door should start to close. Should the barrel be turning
in the upwards direction press the stop button. Reverse the membrane ribbon on the pins.
5 Press and release the down button ( ). If the door closes, press the stop button and in the top
left corner is a bank of 5 dip switches
(fig 5.2) flick the second from top dip switch to the right.
You should now have to press and hold the down button for the door to close.
1 Slide the black cover down on the remote control
handset and you will reveal four buttons
(fig 5.1) .
2 Press and hold the left button
( )
, then press and
hold the right button
( )
if the door moves then
the handset is already programmed in, please repeat
with all other handsets if they are all programmed
please proceed to 'Direction of rotation Section',
if not then carry on to step 3.
3 With the handset in hand, located the red learn
button on the top right hand side of the board next
to the digital display
(fig.5.2) and press and hold till
the digital display comes up S.T.U then release.
4 Press and release the top button on the handset twice.
5 The S.T.U display will flash quickly to indicate success.
6 Repeat for all handsets.
fig.5.1
fig.5.2
10
5. Programming Remote Control
Handsets
(HOLD TO RUN)
- TYPE 1