9
10
10. Locate the Long Cable (82) and notice that there
is a ball on one end and eyelet on the other end.
Route the eyelet end of the Long Cable (82) up
under the lat bar rest on the Weight Guide Frame
(14), down through the indicated hole, back up
through the next hole, and then down between
the Weight Guides (9) as shown.
11. Insert the end of the Long Cable (82) into the
hole in the center of the Weight Carriage (15).
Attach the Cable using an M10 x 65mm Bolt (35),
two M10 Washers (37), two 23mm Spacers (38),
and an M10 Nylon Locknut (29).
12 Lift the Long Cable (82) in the location shown.
Attach two Pulleys (24) inside the bracket on the
Weight Guide Frame (14) using two M10 x 50mm
Bolts (84) and two M10 Nylon Locknuts (29).
82
11
15
12
29
84
24
82
14
35
37
37
29
9
14
Lat Bar
Rest
82
38
38
13
82
14
34
29
37
83
24
13. Lift the Long Cable (82) in the location shown.
Attach two Pulleys (24) inside the Weight Guide
Frame (14) using two M10 x 75mm Bolts (34),
four M10 Washers (37), four 17mm Spacers (83),
and two M10 Nylon Locknuts (29).
37
37
37
83
83
83
