8
8.
Set the two Weight Bumpers (18) over the indi-
cated holes in the Weight Guide Base (4). Set the
Weight Carriage (15) on the Weight Bumpers.
Insert the two Weight Guides (9) through the
Weight Carriage (15). Attach the Weight Guides
to the Weight Guide Base (4) using two M8 x
72mm Bolts (33), four M8 Washers (36), and two
M8 Nylon Locknuts (30).
7.
Press the two 48mm Round Inner Caps (42) into
the weight tubes on the Weight Carriage (15).
Make sure the Weight Carriage is turned so
the weight tubes are near the top, as shown.
Attach the lower Carriage Bushing (16) to the
Weight Carriage (15) using an M10 x 65mm Bolt
(35), two M10 Washers (37), the 51mm Spacer
(39), and an M10 Nylon Locknut (29).
42
42
15
Weight Tube
35
37
39
37
16
29
6.
Press a 60mm Square Inner Cap (28) into the
Left Frame (12). Attach the Left Frame to the left
Uprights (7, 8) using four M10 x 78mm Bolts (31)
and four M10 Nylon Locknuts (29). Do not tight-
en the Locknuts yet.
Assemble the Right Frame (10) on the right
Uprights (7, 8) in the same manner.
Attach the Center Frame (11) to the Right and
Left Frames (10, 12) using four M10 x 78mm
Bolts (31) and four M10 Nylon Locknuts (29).
Tighten the M10 Nylon Locknuts (29) used in
steps 1–6.
29
28
29
31
31
31
31
10
11
Decal
12
29
29
6
7
8
7
8
8
7
15
18
4
36
30
9
33
9
9.
Press a 60mm Square Inner Cap (28) into the
end of the Weight Guide Frame (14).
Hold the Weight Guide Frame (14) on top of the
Center Frame (11) and the Weight Guides (9).
Attach the Weight Guides to the Weight Guide
Frame using two M8 x 72mm Bolts (33), four M8
Washers (36), and two M8 Nylon Locknuts (30).
Attach the Weight Guide Frame (14) to the
Center Frame (11) using two M10 x 78mm Bolts
(31), two M10 Washers (37), and two M10 Nylon
Locknuts (29).
31
37
11
14
29
9
33
36
28
36
30
