Tracker Hunter Tracker G400, Руководство пользователя

Страница: 38 / 136

38
Switching ON
1. Place the device where GPS antenna 1
1
.
.
4
4
has unobstructed access/view to the sky.
2. Switch power ON.
The green light 1
1
.
.
2
2
will turn on for a few seconds.
When the green and red lights flash at three-second intervals, the device is searching for GPS satellites.
The device is operational when the green light alone is blinking.
3. Please verify the device functionality with a test call and test location. For this you will have to start using
Tracker Hunter software in your mobile phone.
TIPS:
Satellite connection is best achieved in the open air.
To see the amount of satellites available, go to Tracker Hunter > Main menu > Messages (open the positioning
message)
The GPS power of the device should be set to Full power in the beginning and can be set to economy or off when
the target moves slowly or not at all. (Power adjustment is made from the Hunter software.) If you are using A-
GPS, power saving mode is adequate. (see GPS power modes)
The device will not necessarily function properly if GPS position is not gotten before the device is put on a dog. In
case the device loses GPS satellites for 30 minutes, e.g. GPS antenna is facing down or the dog is indoors, the
position must be searched again, as you did in startup phase.
The device sends fresh GPS position to the hunter‟s device when the hunter acquires it. In case the device is not
able to get GPS position it will send last known location from the memory after 5 minutes.
Putting the collar on
1. If the device is attached to a collar, it is important that the device is installed as shown in the picture 2
2
The power switch should face the neck of the dog
The microphone is located next to the charging socket. Install it towards the muzzle of the dog. 2
2
.
.
1
1
The collar buckle is placed on the other side of the GPS antenna in order to force the GPS antenna to face
the sky.
Switching OFF
1. Turn off the device by turning the power switch 1
1
.
.
3
3
from “On” -position 1½ rounds to “Off” -position. You
should turn the switch within 30 seconds, but not faster than 5 seconds. Turning of 1½ rounds instead of ½
round is needed so that in case branches hit the power switch when the dog is hunting, power is not
accidentally switched off.
The red light
1 1 . . 2 2
will be lit for two seconds and the device starts shutting down.
TIPS!
After switching off, the GPS searching still continues for some seconds and you can see the lights blinking.
The device cannot be switched off from the power switch if some form of tracking is active. First stop the tracking
from Tracker Hunter, then the device can be switched off.