Basic safety instructions
TR-Electronic GmbH 2005, All Rights Reserved
Printed in the Federal Republic of Germany
Page 34 of 43
TR - ECE - BA - DGB - 0046 - 06
08/23/2016
2.8 Personnel qualification; obligations
All work on the measuring system must only be carried out by qualified personnel.
Qualified personnel includes persons, who, through their training, experience and
instruction, as well as their knowledge of the relevant standards, provisions,
accident prevention regulations and operating conditions, have been authorized by
the persons responsible for the system to carry out the required work and are able
to recognize and avoid potential hazards.
The definition of “Qualified Personnel” also includes an understanding of the standards
VDE 0105-100 and IEC 364 (source: e.g. Beuth Verlag GmbH, VDE-Verlag GmbH).
Define clear rules of responsibilities for the assembly, installation, start-up and
operation. The obligation exists to provide supervision for trainee personnel !
2.9 Safety informations
Destruction, damage or malfunctions of the measuring system and risk
of physical injury!
-
De-energize the system before carrying out wiring work or opening and
closing electrical connections.
-
Do not carry out welding if the measuring system has already been wired up
or is switched on.
-
Ensure that the area around the assembly site is protected from corrosive
media
(acid, etc.).
-
Avoid any shocks (e.g. hammer-blow) on the shaft while mounting.
-
Do not open the measuring system.
The measuring system contains electrostatically endangered circuit elements and
units which can be destroyed by an improper use.
Contacts of the measuring system connection contacts with the fingers are to be
avoided, or the appropriate ESD protective measures are to be applied.
Disposal
If disposal has to be undertaken after the lifespan of the device, the respective
applicable country-specific regulations are to be observed.
