Disposal
TR-Electronic GmbH 2019, All Rights Reserved
Printed in the Federal Republic of Germany
Page 36 of 47
TR-ECE-BA-GB-0138 v04
08/20/2021
Insert fastening screws (9) via the through holes (2) and screw them through the
threaded holes (8) using a Torx key in pairs and cross according to Figure 14 with a
torque of 3 Nm.
Lost fastening screws shall be replaced only by original screws, see chapter 9.4 on
page 46.
Figure 14: To screw the connection cap - sequence
7.6 Equipotential bonding conductor
An equipotential is required for systems in potentially explosive areas.
This is to be
done with a minimum wire diameter of 4 mm
2
.
(1): Connection for equipotential
bonding conductor, corrosion-
resistant
Consisting of lug, locking element
and screw
Figure 15: Equipotential bonding conductor
– Connection
8 Disposal
Electronic waste is hazardous waste. The applicable country-specific regulations are
to be adhered to for disposal.
