Printed in the Federal Republic of Germany
TR-Electronic GmbH 2019, All Rights Reserved
08/20/2021
TR-ECE-BA-GB-0138 v04
Page 33 of 47
Adapt the cable inlet into the threaded hole (7) of the connection cap (5) and fully
tighten the connection element (1).
Figure 7: To screw in the cable inlet into the connection cap
Remove the six fastening screws (6) and pull off the connection cap (5) without cant-
ing.
Figure 8: Remove connection cap
Determine the length of the conductor (A) and the length of the shielding braid (B) re-
quired for installation. The cable is prepared by partially removing the outer enclosure
where the isolated conductors need to be exposed (A). Pull back the shielding braid
over the enclosure (C).
(A)
(B)
(C)
Figure 9: Prepare cable
Loosen grommet nut (4), to loose the sealing (3).
Figure 10: Loosen grommet nut
