7.
Alternating flashing
8.
Bi-Directional Pulsing
9.
Bi-directional Chasing
10.
Steady on
11.
Strobing
12.
Random Flashing
13.
Bi-directional chasing with flashing
14.
Pulsing to Strobing feature.
15.
Bi-Directional Strobing
16.
Fade in / Fade out
NOTES:
1.
Light set must be plugged into working outlet for remote control to function.
2.
The remote control unit is the only way to change the function setting of this product.
3.
When using the remote to turn your set ON, there may be a slight delay before the light pattern starts
working.
4.
To change the light pattern, it is recommended to wait a few seconds after each time you press the
“FUNCTION” button until you reach the desired pattern/function.
5.
If the lights do not change function or the set does not turn on or off with the remote, see the trouble
shooting section.
6.
If there is a power interruption, including if used on a switched outlet, on a timer, or power failure, the
system’s memory will retain the last light pattern displayed.
7.
The operating distance of the remote is up to 100 feet (30 meters). Distance may vary due to other
radio transmitters in the area (cell phones, Wi-Fi signals, wireless phones, intercoms, baby monitor,
etc.), microwave ovens, computers, materials used in the construction of your home, trees, hills,
bushes and other items that may attenuate the radio signal.
8.
The battery in the remote will drain and become depleted very quickly if the remote is place where
one (or both) of the buttons on the remote are continually pushed (such as placing an item on top
of them, or storing the remote upside down).
NOTES:
A.
When multiple light sets are lighted, pressing the FUNCTION button will change all sets to the next
pattern. If the set are preprogrammed, then they should all change to the same next pattern.
B.
These are Radio Frequency controlled devices. All sets within the effective range will be affected
and controlled using any one remote.
C.
If used with a mechanical / digital timer, only one timer must control all sets. In this case, do not turn
sets off using the remote or the sets will not turn on with the timer.
D.
Due to component tolerances, there will be cycle time differences between sets.
WARNING:
•
Do not expose the remote control to moisture.
•
Remove battery when not used for extended period of time, or when depleted.
•
Dispose of batteries properly by following directions on batteries.
•
Use only 12V Alkaline battery type 23A for replacement, use of other batteries may damage remote.
Troubleshooting Instructions:
•
If lights do not change function or turn off or on when a button is pushed:
1.
Check that the light on the remote is illuminating and not dim:
a.
Check that battery is inserted properly (+ and -) and making contact (typically LED would
not be illuminating in this condition), see page 1 for battery installation details.
b.
Clean battery and remote terminals.
c.
Replace battery, see page 1 for battery replacement details.
