CAEDMON ECO DEISGN SMOKE CONTROL ISSUE No. 02 10/10/2017
5
Connect the receiver box to the cable near the stove, insert 4 x AA batteries.
Place the 9v battery into the handset.
To open the air vent press the smallest button on the handset at the same time as the button
next to the arrow pointing upwards. To close the air vent, just press the button next to the
arrow pointing downwards.
TO INSTALL EXTERNAL AIR SUPPLY
Put one jubilee clip over the flexi vent pipe. Push the vent pipe onto the rear air outlet on
the stove and tighten the jubilee clip. Drill a 100mm hole through the wall with a core drill
and push the vent pipe through the wall, cutting to correct length. Put the second jubilee
clip round the vent pipe then fasten to louvre grill. Back fill round the outside of the vent
pipe with insulating material to prevent draught getting into the house. Then fasten the
louvre grill onto the wall.
TURBO BURNER
There is a Turbo Burner which brings air in allowing plenty of oxygen into the rear and top
of the stove, thus burning off gases which normally do not ignite. This gives the stove more
efficiency and better combustion, less pollution. The turbo burner is built in and needs no
adjustment.
LIGHTING THE STOVE
When ready to light the stove for the first time, make sure that everything is removed from
the ashpan, and then open the lever under the door to the left, this is operated by hand with
a glove or by foot. Then slide the air inlet on the right hand side of the stove towards the
front to let air in under the grate, this is meant for cold start or to be used when refueling.
First burn some newspaper in the stove, with the door closed, to warm the flue, as there
may be down draught initially. The temperature in the flue has to be increased to change the
down draught to up draught. If down draught persists, try burning a blow torch in the stove,
facing the flue for a minute or two. If there is a soot door fitted, try warming the flue
through the soot door. If this does not work, call in your installer. If the stove has not been
lit for a while, the chimney should be checked for blockages before lighting.
When ready to light the stove, put a small piece of fire lighter, about 25mm square is big
enough, and then add small sticks, taking care not to smother the flames. When the sticks
are well alight add small logs, gradually increasing the size. Once the fire is well
Established and hot the bottom air slide can be closed. A stove handle cover is included
