CAEDMON ECO DEISGN SMOKE CONTROL ISSUE No. 02 10/10/2017
7
Fuel overloading
The maximum amount of fuel specified in this manual should not be exceeded, overloading
can cause excess smoke.
Operation with door left open
Operation with the door open can cause excess smoke. The appliance must not be operated
with the appliance door left open except as directed in the instructions.
Dampers left open
Operation with the air controls or appliance dampers open can cause excess smoke. The
appliance must not be operated with air controls, appliance dampers or door left open
except as directed in the instructions.
FUELS
This appliance has been tested using seasoned wood logs. Logs need to be dry, seasoned
logs, ie. No more than 20% moisture content, maximum log length up to 350 mm x 100mm
diameter. Small pieces of kiln dried timber can burn very hot, take care that the fire does
not get out of control. The stove is designed to burn wood.
Warning – using a non-approved fuel may cause damage to the stove and will not be
covered by our guarantee. Wood needs to be dry and seasoned (maximum 20%
moisture content)
Do not burn any liquid fuel. Do not burn wood pellets.do not burn wood chips. Do not
burn any rubbish on the stove.
CLEANING THE STOVE AND FLUE
It is important to remove the ashes regularly, if the ash builds up through the grate, the
grate could overheat and distort.
Open the fire door with the stove glove provided, and, using the tool, gently pull out the
ashpan a little way. Then remove the tool and slot it in from the top of the slot in the
middle of the ashpan. The tool will then have a firm grip on the ashpan. Carefully carry
the ashes out to dispose of them, or use a ‘Tippy’ or similar ash carrier.
When the stove is being used regularly, it will be necessary to remove the baffle once a year
to clean any debris that may have collected there. The chimney/flue should be swept and
checked every year. The glass on the stove door can be cleaned (better when the glass is
cool), using a damp cloth, or sponge pan scrubber for any stubborn marks. Stove glass
cleaner may be used if required.
The body of the stove can be brushed with a soft brush, do not use water on the paint work.
If, in time, the body of the stove needs touching up, a touch-up aerosol of paint, the same as
