CAEDMON ECO DEISGN SMOKE CONTROL ISSUE No. 02 10/10/2017
3
UNPACK THE STOVE
Carefully cut the straps and lift the box up over the top of the stove. Remove the packing
from round the outside of the stove,
leaving the plastic cover on if building work is still
in progress, it is important to protect the paint finish from any damage, water, dust or
fire
cement
. Using a 17mm spanner, remove the two bolts attaching the stove to the pallet,
and then replace the bolts into the stove legs, these are used as levelling bolts if required.
Open the stove door and remove the packaging from inside the stove, there is some behind
the baffle, and the heavy one inside the stove contains the spigot for the flue outlet.
Remove the bag inside the ashpan, this contains the operating tool, instructions, and a pair
of stove gloves.
CLEARANCES
The Caedmon Eco Design needs to be sited next to and on a non-combustible surface. A
minimum clearance of 150mm at the sides 300mm above and 50mm from the back of the
stove body will allow air circulation and not impede the performance of the stove.
If it is necessary to site the stove near a combustible surface a minimum of 200mm at the
back and 400 mm at the sides must be maintained from combustible materials.
It is a requirement that this appliance is installed on a solid, level, non-combustible hearth
conforming to current Building Regulations. The Caedmon Eco Design has been tested for
hearth temperatures and the maximum temperature was 56 degrees so is also suitable for a
12mm hearth.
INSTALLATION
A minimum flue draught of 24 Pa is required for nominal heat output. The Appliance must
be installed on a floor with an adequate load-bearing capacity. If an existing construction
doesn’t meet the prerequisite, suitable measures (e.g. load distributing plate) shall be taken
to achieve it. As referred to in document J in the Building Regulations, the Caedmon Eco
Design requires a minimum of 1100 sq mm of fixed ventilation (this equals ventilation of
approximately 33mm x 33mm).
It is important that any inlet grilles are so positioned that they are not liable to blockage. It
is essential that the stove has adequate air supply for combustion and ventilation.
Apertures provided for this purpose shall not be restricted.
Please note where either the external air kit or remote control kit are fitted an air vent
is still required in the same room as the stove to the above specification.
Fit the collar on the top of the stove. A flat-bladed screw driver and 8mm spanner will be
