Town & Country Fireplaces TCWS.54CODE, Инструкция по установке и эксплуатации

Страница: 33 / 36

APPENDIX
Figure 47: Clearing the securing tab.
Figure 48: Right panel.
Figure 49: Access panel.
1. Remove front panel base. Also remove rear panel base if Black Diamond Burner is fitted (Figure 46).
2. Push up on the heat shield, at the right end of the unit near the middle, enough to clear the securing tab (Figure 47).
3. Pull the top of the right panel toward the center of the unit using caution not to scratch the back panel (Figure 48).
4. Once the right panel is tilted inwards it can be lifted clear of the burner tray and removed.
NOTE: The right hand side rock cluster may need to be removed to prevent damage while working through the
access hole. Covering the sand with paper or cardboard will also minimize disturbance during the servicing process.
5. The access panel is now visible (Figure 49) and can be removed.
6. Reassemble in reverse order.
WARNING: The control box shield, access
panel and gasket must be replaced. Failure
to do so will overheat and cause premature
failure of the control.
Figure 46: Front panel base.
FRONT PANEL BASE
33
TCWS.54CODE_041115-36 5055.5401-A
Quick Panel Removal for Valve Service