Town & Country Fireplaces TCWS.54CODE, Инструкция по установке и эксплуатации

Страница: 13 / 36

1. On a flat surface, lay one 75 1/4” (#4) stud on its end and at the top of your working area. This will be the top most
horizontal stud.
2. Position all three 25” studs (#6) vertically with the center stud aligning with the center of the above (#4) horizontal
stud. Use supplied screws to affix the tops of the vertical studs to the horizontal stud.
3. Position two - 55” studs (#2) on either side of the three vertical studs (#6), centering them so that they are approxi-
mately 56” from each other while being evenly centered in relation to the top (#4) stud. Use supplied screws to affix
the tops of these studs to the top horizontal stud.
4. Position stud (#5) horizontally along the bottom ends of the three 25” (#6) vertical studs while aligning the ends of
this stud with the two 55” (#2) studs. This stud has an angled bottom which makes one side of the stud higher on
one edge than the other. The higher edge will face toward the fireplace once assembled. Use supplied screws to affix
this stud to all five vertical studs (#2) & (#6).
5. Position stud (#7) horizontally approximately 12” from the bottom of the two vertical studs (#2). Make sure that the
slot side is facing up. Affix the ends of this stud to the vertical (#2) studs.
6. With the tabs bent outward, position the two 55” (#3) studs vertically, one at each end of the top most horizontal stud
(#4) and affix.
7. Place the final 75 1/4” (#4) horizontal stud at the bottom of the assembly and affix to the four vertical studs.
8. Turn the assembly over and affix the remaining screws to the other side of the frame.
1. Frame assembly
Figure 18: TCWS54CODE Steel frame assembled.
2
2
3
3
4
4
5
6
7
FRONT VIEW (slightly angled)
BEND OUT FRAMING
TABS TO FRONT
WIDE FACE
FORWARD
SCREW INTO
SIDE
SLOTS UP
LONG EDGE UP
6 6
13
TCWS.54CODE_041115-36 5055.5401-A