TOUGH-WORKS TLGS625, Инструкция по эксплуатации

Страница: 11 / 20

BD4603
11
WARNING
!
OPERA
TION
TLGS625
The operation of any grinder can result in
foreign objects being thrown into your eyes,
which can result in severe eye damage.
Before beginning power tool operation, always
wear safety goggles or safety glasses with
side shields and a full face shield when needed.
We recommend Wide Vision Safety Mask for
use over eyeglasses or standard safety gl-
asses with side shields.
TEST RUN
Once mounting is complete and adjustments are
done to your satisfaction, you are ready to test
the machine.
To test run the grinder/sander:
1. Plug the machine into the power source.
2. Stand to the side of the grinding wheel and
turn the grinder ON.
The machine should run smoothly with little or
no vibration or rubbing noises. Strange or un-
usual noises should be investigated and corr-
ected before operating the machine further.
If the machine seems okay, stay out of the line
of rotation of the grinding wheel and let it run for
1 to 2 minutes to make sure the wheel is stru-
cturally sound.
All grinding wheels have the potential of b-
reaking apart during operation, causing serious
personal injury or death! Always stand to the
side of the grinder when turning it ON and
wear the proper safety equipment to protect
yourself.
WARNING
!
The grinder is a safe tool when used properly.
In addition to the safety instructions in this man-
ual, the most important safety consideration is to
use common sense at all times. What may be
okay in one situation, may not be safe in another.
Read the following statements to protect yourse-
lf before grinding:
• Make sure all guards and eye shields are in
place.
BEFORE GRINDING
• Remember that grinding often produces sparks.
DO NOT allow anyone to stand in the path of the
sparks. DO NOT grind near flammable liquids or
gases.
• Wear the proper protective clothing. Remember
that particles flying off of a grinding wheel will be
traveling very fast. Wear safety glasses or a face
shield, a dust mask, earplugs, a leather apron and
heavy leather boots.
• DO NOT lean into the workpiece in a manner that
may cause your hands to move into the spinning
wheel if the workpiece slips off.
• Concentrate on the task at hand. STOP grinding/
sanding if there are distractions.
NOTICE! The grinder is designed for use with
hard metals only. Soft metals and wood pro-
ducts should only be used on the sanding belt.
They will quickly load the grinding wheel surface
and ruin its abrasive qualities.
OPERATING GRINDER
To grind with the grinding wheel:
1. Fill the coolant tray 3/4 full with water.
2. Move the red switch to the ON position
.
3. Allow the machine to run for at least 1 full minute
to ensure that the grinding wheel is safe for use.
4. Grasp the workpiece tightly and properly support
it on the tool rest.
5. Place the workpiece against the front surface of
the wheel with moderate pressure, moving it back
and forth in a steady, even motion.
6. Regularly dip the workpiece into the coolant tray
to cool it off.
7. When you are ready to stop the grinder, move the
red switch to the OFF position. At this point, DO
NOT continue grinding and DO NOT manually
stop the grinding wheel with your workpiece!
Note: Using too much pressure will slow the motor
and may damage the wheel. Using too little pres-
sure will make the workpiece bounce around and
you will not make good contact with the wheel.
CAUTION! The sanding belt will remove large amo-
unts of material quickly, including your skin. DO NOT
touch the sanding belt and always position your
hands so they will not slip into the belt or get caught
SANDING