TOUGH-WORKS TLGS625, Инструкция по эксплуатации

Страница: 12 / 20

12
BD4603
TLGS625
in the belt.
OPERA
TION
The 2 in. sanding belt on the machine works great
for non-ferrous metals and wood products. A wide
variety of belts are also available for many types
of materials and stages of finishing.
To sand a workpiece:
1. Before starting the machine, adjust the angle
of the tool rest so your workpiece is supported
and the area you wish to sand is parallel with
the sanding belt as illustrated
（
in Fig 7
）
.
2. With the machine plugged into power, stand
to the side of the grinding wheel and move
the red switch to the ON position.
Figure 7
3. Allow the machine to run for at least 1 full mi-
nute to make sure that the grinding wheel is
not going to fly apart and injure you, then move
to the front of the machine.
4. Grasp the workpiece tightly and properly
support it on the tool rest.
5. Press the workpiece evenly against the sa-
nding belt with light pressure (see Fig 8 and 9).
DO NOT press hard. Let the rotation of the
belt do the work.
6. Remove your workpiece regularly to check
the progress the sander has made.
Remember you can always remove more
material but you cannot add it.
7. When you are finished sanding, move the red
switch to the OFF position. DO NOT continue
sanding and DO NOT manually stop the san-
ding belt with your workpiece.
Figure 8
Figure 9