TOUGH-WORKS TLGS625, Инструкция по эксплуатации

Страница: 5 / 20

ELECTRICAL SAFETY
BD4603
5
TLGS625
A separate electrical circuit should be used for your
machines. This circuit should not be less than #12
fuse. If an extension cord is used, use only 3-wire
extension cords which have 3-pronged grounding
type plugs and matching receptacle which will
accept the machine’s plug. Before connecting the
machine to the power line, make sure the switch
is in the "OFF" position and be sure that the ele-
ctric current is of the same characteristics as
indicated on the machine. All line connections
should make good contact. Running on low voltage
wire and should be protected with a 20-A time-lag
will damage the machine.
GROUNDED
OUTLET BOX
CURRENT
CARRYING
PRONGS
GROUNDING BLADE
IS LONGEST OF THE 3 BLADES
GROUNDED OUTLET BOX
GROUNDING
MEANS
ADAPTER
Figure. 1
Figure. 2
MOTOR SPECIFICATIONS
Your machine is wired for 120 V, 60Hz
alternating current. Before connecting the
machine to the power source, make sure
the switch is in the "OFF" position.
GROUNDING INSTRUCTIONS
!
DANGER!
DO NOT EXPOSE THE MACHINE TO RAIN OR
OPERATE THE MACHINE IN DAMP LOCATIONS.
THIS MACHINE MUST BE GROUNDED
WHILE IN USE TO PROTECT THE OPERATOR
All grounded, cord-connected machines: In the
event of a malfunction or breakdown,grounding
provides a path of least resistance for electric
current to reduce the risk of electric shock. This
machine is equipped with an electric cord having
an equipment grounding conductor and a gro-
unding plug.
FROM ELECTRIC SHOCK.
The plug must be plugged into a matching outlet
that is properly installed and grounded in accor-
dance with all local codes and ordinances.
Do not modify the plug provided–if it will not fit
the outlet, have the proper outlet installed by a
qualified electrician.
Improper connection of the equipment-grounding
conductor can result in risk of electric shock. The
conductor with insulation having an outer surface
that is green with or without yellow stripes is the
equipment-grounding conductor. If repair or repl-
acement of the electric cord or plug is necessary,
do not connect the equipment-grounding condu-
ctor to a live terminal.
Check with a qualified electrician or service per-
sonnel if the grounding instructions are not com-
pletely understood, or if in doubt as to whether the
machine is properly grounded.
Use only 3-wire extension cords that have 3-pronged
grounding type plugs and matching 3-conductor
receptacles that accept the machine’s plug, as shown
in Fig. A.Repair or replace damaged or worn cord
immediately.