Using the two holes 1/2" from the bottom of the rails,
slide the fixed pin into the hole in the outside left rail
(Figure 2b).
Pull the 3/8" retractable pin on the right side and move
the pin over the hole. Release the pin (Figure 3). Move
the Folding Platform until the retractable pins engage
completely (Figure 4).
Align the Telescoping Squat Stand over the Folding
Platform struts until the Squat Stand pins contact the
top of the Folding Platform struts (Figure 5).
Pull the retractable pins and adjust the Telescoping
Squat Stand to the desired height, then release the pins
and raise or lower the Telescoping Squat Stand until
both pins engage in one of the three adjustment holes
in the Folding Platform struts (Figure 6).
INSTALL THE GLIDEBOARD.
Loosen the plyo-strut locking handle (Figure 1). Lower
the rails flat to the lowest position beneath the ladder
hooks (Figure 2). Raise the rail assembly to an A-frame
position (Figure 3).
Lift the glideboard and lower it onto the rails (Figure 4).
Make sure the logo on the board is right side up and the
D ring at the top of the board is near the rail hinge. The
glideboard will rest against the glideboard stop when
the glideboard is properly attached (Figure 5).
7
TOTAL GYM 26000 OWNER’S GUIDE
OWNER’S GUIDE
TOT
AL
GYM 26000
800 541 4900 EFISPOR
TSMEDICINE.COM
7
5/16"
3/8"
Figure 2b
Figure 3
Figure 4
Figure 5
Figure 6
Glideboard
Stop
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Fixed Pin
