INSTALL FOLDING FOOT HOLDER.
To assemble the Folding Foot Holder, attach the upper
foot pads to the lower foot pad assembly (Figure 1).
Position the Folding Foot Holder between the upper rails
(Figure 2). Insert the retractable pin into the right rail
(Figure 3). First, install one cap screw in the left rail,
using an Allen wrench (Figure 4). Then, repeat this
procedure with the right rail.
The Folding Foot Holder is now ready to use (Figure 5).
To begin using the Folding Foot Holder, sit on the top of
the glideboard, push in the center post snap button and
raise the upper foot pad assembly (Figure 6a). Place
your heels past the pads of the lower foot pad assembly
and slide the upper foot pad assembly down the center
post until the snap button re-engages (Figure 6b).
The Folding Foot Holder should be lowered to the
“down” position after use to avoid interference with
the glideboard during other exercises. To return the
Folding Foot Holder to the down position, pull the
inside right rail retractable pin and lower the Folding
Foot Holder (Figure 7).
With the Glideboard, Retractable Dip Bars, Folding
Platform/Telescoping Squat Stand and Folding Foot
Holder installed, your Total Gym 26000 is assembled
(Figure 8).
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6a
Figure 6b
Figure 7
Figure 8
