CLEANING/MAINTENANCE/STORAGE:
CLEANING AND MAINTENANCE:
To enjoy outstanding performance of your heater for years make sure to perform the following maintenance
activities on a regular basis:
Keep exterior surfaces clean.
-Use warm soapy water for cleaning. Never use flammable, corrosive or abrasive cleaners.
-While washing your unit, be sure to keep the area around the burner and pilot assembly dry at all time.
If the gas control is exposed to water in any way, do NOT try to use it. It must be replaced.
After a long break from operation, the unit should be inspected for spiders, spider webs or other insects.
Air flow must be unobstructed. Keep controls. Burner and circulating air passageways clean.
Signs of possible blockage include:
-Gas odour with extreme yellow tipping of flame.
-Heater does NOT reach the desired temperature.
-Heater glow is excessively uneven.
-Heater makes popping noises.
Spider and insects can nest in burner or orifices.
This dangerous condition can damage heater and render it unsafe for use. Clean burner holes by
using a heavy-duty pipe cleaner.
Compressed air may help clear away smaller particles.
Carbon deposits may create a fire hazard. Clean reflector and glass tube inside with soapy water if any
carbon deposits develop. Always be careful when cleaning the glass tube.
STORAGE:
Between uses:
Turn the control knob to “OFF” position.
Turn LPG cylinder to “OFF” position.
Store heater upright in an area sheltered away from weather conditions (such as rain, sleet, hail, snow).
If desired, cover heater to protect exterior surfaces and to help prevent dust and debris collecting in air passages.
During periods of extended inactivity or when transporting:
Turn the control knob to “OFF” position.
Disconnect LPG Cylinder and move to a secure, well-ventilated location outdoors.
DO NOT store in a location that will exceed 50 degrees C.
Store heater upright in an area sheltered away from weather conditions (such as rain, sleet, hail, snow).
If desired, cover heater to protect exterior surfaces and to help prevent dust and debris collecting in air passages.
WARNING
FOR YOUR SAFETY
Do not touch or move the heater for at least
45 mins. after use.
Allow all burner elements to cool before
touching.
NOTE
In a salt-air environment (such as near an
ocean) corrosion occurs more quickly than
normal.
Frequently check for corroded areas and
repair them promptly.
Wait until heater is cool before covering
11
