INSTALLATION
OPERATION:
PREPARATION:
WARNING:
Never use the heater while it is raining, the glass tube would break when it suddenly met water.
Always turn off the heater while there is a rain.
Never splash any liquid to the glass tube when the heater is working
The glass tube will be extremely hot when it is working, never try to touch it and keep the children away
from the heater.
Always ensure the heater stands firmly, the glass tube may break if the heater was falls down onto ground.
Never use the heater if the glass tube has any cracks
Important safety requirements:
THIS APPLIANCE OUTDOOR USE ONLY
1. This appliance shall not be installed or used indoors, in buildings, garages or any other enclosed area.
2. DO NOT place articles on or against this appliance.
3. DO NOT use or store flammable materials near this appliance.
4. DO NOT operate this appliance unless it is fully assembled with reflector and protection guard in place.
5. Installation and repair should be done by a qualified service person. The appliance must be inspected
before use and at least annually by a qualified service person. More frequent cleaning may be required as
necessary. It is imperative that control compartment, burners and circulating air passages of the heater
and light be kept clean.
You will need to purchase an LPG cylinder
You need a suitable size LPG cylinder that can be installed to the
compartment.
You have to use pressure regulator with an outlet pressure complying
with the appliance category. The flexible tube must be approved also.
Connect the hose to the hose connector in the control box
Warning: Always test the hose for leaks with soapy water at both ends.
To Turn On The Heater
1. Open the cylinder control valve 1½ turns in an anti clockwise direction
O
2. Press and turn the variable control knob on the heater to the PILOT position (90 in an anti- clockwise
direction.
3. Whilst in the Pilot position press in the variable control knob and hold in that position for 30 secs. Whilst
holding the knob in the pressed in position press the ignitor button several times until the pilot flame ignites.
Note:
Ÿ
If a new cylinder has just been connected to the heater please allow 60 seconds for the air in the gas
hose to purge out of the pilot jet before pressing the ignitor button.
Ÿ
It is important to hold in the control knob when pressing the ignitor button.
Ÿ
If the plot flame does not ignite repeat step 3 above.
4. After the pilot flame ignites turn the variable control knob to the maximum position and leave in that position
for 5 mins. or more before turning the control knob to the desired temperature setting
To Turn off the Heater
1. Turn the variable control knob to the PILOT position.
2. Press and turn the variable control knob to the OFF position
3. Turn the cylinder control valve to the closed position in a clockwise direction.
lgnitor
Ignitor button
Variable
Control knob
10
