Toshiba RAV-GP1101AT8-E, Руководство по обслуживанию

Страница: 78 / 109

– 78 –
ON
2 3 4 1
ON
2 3 4 1
ON
2 3 4 1
ON
2 3 4 1
ON
2 3 4 1
ON
2 3 4 1
SW804
SW804
SW804
SW804
SW804
SW804
SW 8 04 Operation when pushdown button switch SW 8 01 is pushed
4-way valve relay operation (For RY700, CN70 check)
T u rn on 4-way valve power relay (RY700).
When p us hing SW801 again or when 2 min u te s elap s ed,
the operation ret u rn s to the normal control.
Heater o u tp u t relay operation
(For check RY703, CN703 check)
T u rn on relay for option heater (RY703).
When p us hing SW801 again or when 2 min u te s
elap s ed, the operation ret u rn s to the normal control.
O u t s ide o u tp u t relay operation (RY704, CN704)
T u rn on relay for o u t s ide o u tp u t (RY704).
When p us hing SW801 again or when 2 min u te s
elap s ed, the operation ret u rn s to the normal control.
Forced s tart command
The indoor u nit connected to the s y s tem i s forcedly s tarted.
(The indoor u nit s tart s operation b y s etting of the operation mode on the remote controller.)
Forced s top command
The indoor u nit connected to the s y s tem i s forcedly s topped.
Relay operation change for o u t s ide o u tp u t
[CAUTION]
Do not us e thi s s etting.
[CAUTION]
Altho u gh the s e operation s can
b e performed even d u ring
operation, b a s ically perform
operation while the u nit s top s .
If performing thi s operation
d u ring driving the u nit, it i s
dangero us b eca us e the
pre ssu re may change su ddenly.
9-3-4. Outdoor application operation
Optional connector kit (TCB-KBOS4E)
(1) Peak-cut control
• Saves the power of the outdoor unit by the external peak-cut signal to suppress temporary peak power
dissipation.
• The power saving can be switched to three levels: 75%, 50%, and operation stop.
(2) Night operation
• Reduces the capacity of the air conditioner by the input signal from a commercially available timer
(procured locally) regardless of the outside air temperature or load to reduce operating noise.
(3) Compressor output
• Turns on the no-voltage contact output while the compressor is operating.