~ 31 ~
GB
The maximum extended length of the
remote control cable which can be used is
500 metres. Install the remote controller
where it can be easily operated;
The decorative cover can be removed by
prising the section indicated by the arrow,
using an ordinary flat screwdriver;
The in-built memory backup capacitor will
prevent memory loss during power failure;
For details of setting the remote controller
please refer to the operating instructions in
the Remote Controller Owner’s Manual.
~ 31 ~
R
EMOTE
C
ONTROLLER
Installation of Remote Controllers
Precautions
Low voltage circuitry is used for remote
control communication, and as such, the
remote control cable is subject to the
low-power circuit provision of internal wiring
regulations and therefore it cannot be
brought into direct contact with a high-
voltage AC power line, or housed in the
same conduit tube as a power line.
!
!
Heat Pump AI Models
Flush Wall Mounting
!
!
!
Cooling Only Models
Flush Wall Mounting
Wall Surface Mounting
Make a U-shaped cut-out in the centre of
the top edge of the decorative cover and
pass the 3-core PVC round cable through
the cut out.
!
!
!
!
Batteries (x3)
supplied with the
remote controller
!
3-core PVC cable,
obtained locally
Mounting screws (x2)
obtained locally
Cut out
Wiring of two Remote Controllers
l
With the AI system the air conditioner can be
controlled by two remote controllers the priority is
the last remote controller touched.
l
The remote controllers should be wired as shown
in the diagram below:
1 Connect the remote controller terminals ABC
together in parallel.
2 On the Sub remote controller set the dip SW1
switch 1 to the OFF position.
The total amount of cable between the indoor units and
the remote controllers must not exceed 500m.
Cut-out
Mounting screws (x2)
obtained locally
!
Wall Surface Mounting
Make a U-shaped cut-out in the centre of
the top edge of the decorative cover and
pass the 3-core PVC round cable through
the cut out.
Indoor
Unit
ON Position 1:
OFF Position 1
Sub Remote Controller
Main Remote Controller
DIP
SW 1
Mounting screws (x2) obtained locally
3-core PVC cable, obtained locally
Batteries (x3) supplied
with the remote controller
The maximum extended length of the remote
controller cable which can be used is 500
metres. Install the remote controller where it
can be easily operated.
The decorative cover can be removed by
prising the section indicated by the arrow,
using an ordinary flat screwdriver.
Insert the three batteries (supplied) in order to
prevent the stored clock display and other
settings from being lost, even when the power
switch is set to OFF or when the power fails.
For details of setting the remote controller
please refer to the operating instructions in
the Remote Controller Owner’s Manual.
Mounting screws (x2)
obtained locally
ON
OFF
OFF
ON
Heronhill - for all your Toshiba requirements
Tel: 01823 665660
www.heronhill.co.uk
Fax: 01823 665807
