Toshiba MCY-MAP0401TP Series, Руководство по установке

Страница: 21 / 32

Installation Manual
– 20 –
EN
EN-39 EN-40
4
The 7-segment display indicates .
After the indication, starts flashing on the display.
When the flashing stops and remains lit on the display, the setting is complete.
Interface P.C. board on the outdoor unit
REQUIREMENT
• When 2 or more refrigerant lines are controlled as a group, be sure to turn on all the indoor units in the group before
setting addresses.
• If you set the unit addresses of each line separately, each line’s header indoor unit is set separately. In that case,
the CODE No. “L03” (Indoor header unit overlap) is indicated as running starts. Change the group address to make
one unit the header unit using wired remote controller.
Address setting procedure 2
1
Set a system address for each system using SW 13 and 14 on the interface P.C. board on the outdoor unit
of each system.
(Factory default: Address 1)
NOTE
Be sure to set a unique address on each system. Do not use a same address as another system (refrigerant line) or a
custom side.
(Example) Controlling 2 or more refrigerant lines as a group
System wiring diagram
Auto 1  Auto 2  Auto 3
U. 1. - - - (U. 1. flash)
U. 1. - - - (U. 1. light)
3
2, 4
D600 D601 D602 D603 D604
SW04 SW05 SW15
SW01 SW02 SW03
Outdoor
Indoor
Remote
controller
Indoor Indoor Indoor
Outdoor
(Group control)
Interface P.C. board on the outdoor unit
Switch settings for a line (system) address on the interface P.C. board on the outdoor unit
( : switch ON, : switch OFF)
“–”: not used for system address setting (Do not change their positions.)
Line (system) address
SW13 SW14
1 2 3 4 1 2 3 4
1 – – –
2 – – –
3 – – –
4 – – –
5 – – –
6 – – –
7 – – –
8 – – –
9 – – –
10 – – –
11 – – –
12 – – –
13 – – –
14 – – –
15 – – –
16 – – –
17 – – –
18 – – –
19 – – –
20 – – –
21 – – –
22 – – –
23 – – –
24 – – –
25 – – –
26 – – –
27 – – –
28 – – –
SW06 SW07 SW09 SW10
SW11 SW12 SW13 SW14
1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4
1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4
2FAN_IM_DB04905901-00.book Page 20 Friday, October 24, 2014 3:19 PM