Toshiba HX7+ ASD, Руководство по установке и эксплуатации

Страница: 37 / 257

28 HX7+ ASD Installation and Operation Manual
I/O and Control
The HX7+ ASD can be controlled by several input types and combinations thereof, as well as operate
within a wide range of output frequency and voltage levels. This section discusses the ASD control
methods and supported I/O functions.
The Terminal Board supports discrete and analog I/O functions and is shown in Figure 8 on pg. 32 .
Table 6 lists the names and the default settings of the input and output terminals of the Terminal Board .
See the section titled Terminal Descriptions on pg. 29 for an expanded description of each terminal.
Note: Set the Command Mode to Terminal Board to use the input control lines of the
Terminal Board for command input (Program

Fundamental

Standard Mode
Selection

Command Mode

Terminal Board). Output lines of the Terminal
Board need not be selected to enable the output. However, output lines may be set to
a user-selected function.
Figure 20 on pg. 38 shows the typical connection diagram for the HX7+ ASD system.
Table 6. Terminal Board Terminal Names and Functions.
Default Term.
Setting
Input/Output
Default Function
(also see Terminal Descriptions on pg. 29 )
Circuit Config.
ST Discrete Input
Connect to CC
to activate
(Sink mode)
Sink/Source
Switching
applies to
discrete input
terminals only.
Standby — Multifunctional programmable discrete input. Activation
required for normal ASD operation.
Figure 10 on pg. 36.
RES
Reset — Multifunctional programmable discrete input. Resets a faulted
ASD.
F Forward — Multifunctional programmable discrete input.
R Reverse — Multifunctional programmable discrete input.
S1 Preset Speed 1 — Multifunctional programmable discrete input.
S2 Preset Speed 2 — Multifunctional programmable discrete input.
S3 Preset Speed 3 — Multifunctional programmable discrete input.
S4 Emergency Off — Multifunctional programmable discrete input.
RR
Analog Input
RR — Multifunction programmable analog input

(0.0 to 10 volt input — 0 to 80 Hz output).
Figure 11 on pg. 36.
RX
RX — Multifunctional programmable analog input

(-10 to +10 VDC input — -80 to +80 Hz output).
Figure 12 on pg. 36
II
II — Multifunctional programmable analog input (4 [0] to 20 mADC
input — 0 to 80 Hz output).
Figure 13 on pg. 36.
VI
VI — Multifunctional programmable analog input

(0 to 10 VDC input — 0 to 80 Hz output).
AM
Analog Output
Produces an output current that is proportional to the magnitude of the
function assigned to this terminal.
Figure 18 on pg. 36
FM
OUT1 (C-A)
Switched
Output
Low Frequency — Programmable contact (N.O.).
Figure 16 on pg. 36.
OUT2 (C-A) Reach Frequency — Programmable contact (N.O.).
FLA Fault relay (N.O.).
Figure 19 on pg. 36. FLB Fault relay (N.C.).
FLC Fault relay (Common).
FP
Pulsed Output
Frequency Pulse — an output pulse train that has a frequency which is
based on the output frequency of the ASD.
Figure 17 on pg. 36.
P24
DC Output
24 VDC @ 50 mA output. Figure 14 on pg. 36.
PP PP — 10.0 VDC voltage source for the external potentiometer. Figure 15 on pg. 36.
CC — Return for analog and discrete input terminals.
DO NOT connect to
Earth Gnd.