e-STUDIO203S/203SD TEST COMMAND, TROUBLE CODES 10 - 31
63
13
Light quantity stable width
setting (LT.STABLE RNG.)
[Function]
When the difference between the maximum and the minimum values of the light quantity level
sampled for 3.2sec in the cycle of 100msec in the white balance light quantity stable process is
within the range set with this test command, it is judged as the light quantity is stable. (Note:
The magnification ratio of the AFE gain setting is automatically reflected on the stable width.)
When this test command is executed, the currently set value is displayed.
Enter the adjustment value with [10KEY] and press [START] key. The entered value is stored
and the machine goes into the sub code entry standby mode.
Setting range: 1 – 99 (Light quantity stable width: Complying with 1 – 99 in 4095 gradations.)
Default: 16
[Operation]
The operation is similar to test command 9-04.
64
01
Self print (1by2 mode)
(SELF PRT.)
[Function]
The status of the optical section is ignored and printing of one page is made. Also when the
print command is received from the host, printing is made.
When this test command is executed, warm-up is performed and the ready lamp is lighted.
(Since, however, the scanner is disabled, initializing is not made.)
Enter the code number and press [ENTER/START] key to start paper feed from the selected
cassette and print in the selected pattern.
∗
For 4 – 99, flip.
[Operation]
The operation is similar to test command 21-01.
66
01
FAX soft SW setting
(Executable only when the
FAX is installed.)
[Function]
Use to check the FAX soft SW setting.
Every time when the key is pressed, the bit on the first line is switched 0 and 1.
[Operation]
02
FAX soft SW initializing
(excluding the adjustment
values) (Executable only
when the FAX is installed.)
[Function]
Use to initializing FAX soft SW.
[Operation]
Main
code
Sub
code
Contents
Details of function/operation
Code number
Pattern
Display item
0
1by2
1 BY 2
1
Grid pattern
CHECK
2
White paper
WHITE
3
Black background
BLACK
1) Initial display
∗
[CLEAR] key: FAX control is terminated.
2) Enter a 3-digit value of soft SW No. (To
enter the fourth digit, shift to the left.),
and the press [ENTER] key.
"xxxxxxxx" is the set content.
∗
Select 2: Returns to the soft SW No. entry
display.
3) Select 1
4) Change with 1-8 of [10KEY] and the
press [ENTER] key.
"xxxxxxxx" is the set content.
∗
Select 2: Returns to the soft SW No. entry
display.
5) Select 1
After 2sec, returns to "1) Initial display".
ENTER FAX SOFT SW. #
(3 DIGITS) SW.___
No.### xxxxxxxx
CHANGE? 1:YES 2:NO
No.### xxxxxxxx
USE # KEY 12345678
No.### xxxxxxxx
STORED? 1:YES 2:NO
STORED
1) Initial display
After 2sec, FAX control is terminated.
INITIALIZED
