55
7
MISFEED REMOVAL
When the misfeed (
) indicator blinks or
blinks in the display, the unit will
stop because of a misfeed. When the ADF misfeeds an original sheet, the unit will
stop and the ADF misfeed (
) indicator will blink, while the misfeed (
) indicator
will remain off. For a misfeed of originals in the ADF, see "E: Misfeed in the ADF
(Peripheral device)" (p.59).
1
Open the multi-bypass tray,
and then open the side
cover.
2
Check the misfeed location.
Remove the misfed paper following the instructions for each
location in the illustration below. If the misfeed (
) indicator
blinks, proceed to "A: Misfeed in the paper feed area" (p.56).
A letter and a number appear
alternately.
The scan head locking switch is locked. Unlock
the scan head locking switch.
A letter and a number appear
alternately.
The unit will not function. Turn the power switch
off, remove the power cord from the outlet, and
contact your authorized service representative.
–
While pressing the start
(
) key, "02" is displayed.
Check the toner cartridge and make sure that the
seal is not still affixed.
–
Indication
Cause and remedy
Page
If paper is misfed here, proceed
to "
A: Misfeed in the paper
feed area
" (p.54).
If paper is misfed here, proceed to "
B:
Misfeed in the fusing area
" (p.55).
If the misfed paper is seen from
this side, proceed to "
C: Misfeed
in the transport area
" (p.56).
If paper is misfed here,
proceed to "
D: Misfeed in the
lower paper feed area
(Peripheral device)
" (p.56).
